Hardware knowledge Site

Samsung s5830i flashing tutorial

Samsung S5830i uses the Android 2.3 system with its own Touchwiz 3.0 interface, and the 3.5-inch HVGA (480x320) screen also conforms to this The low-end positioning of the machine. So how to use this Samsung s5830i flashing tutorial? Let’s introduce the Samsung s5830i flashing tutorial, let’s take a look.

Step 1. First enter the Recovery mode to perform double clearing (please skip it if you cannot enter), as shown in the figure:

Step 2. Execute [wipe data/factory reset] and [wip cache partition] in sequence. After completion, turn off the phone (remove the battery directly), and the phone will enter the flash mode (press and hold: volume down, HOME button, and power button at the same time in the shutdown state). As shown in the picture:

Step 3. After the phone enters flashing mode, we open the ODIN flashing tool on the computer and configure the flashing package. The phone passes the data Connect the cable to the computer, as shown in the picture:

Step 4. The software automatically flashes the machine, and PASS is displayed on the COM port to indicate that the flashing is completed. , the phone restarts automatically. The first restart may be slow, please wait patiently.

The above is the Samsung s5830i flashing tutorial. Please note that when using ODIN to flash the phone, please wait patiently. Pay special attention to the package of files when flashing, and the data cable must be plugged into the USB interface at the back of the computer chassis.